Dascom 7010 Peeler Installation and User Guide Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Impresoras Dascom 7010 Peeler Installation and User Guide. Dascom 7010 Peeler Installation and User Guide User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Installation Guide 7010 Peeler Unit
This guide is provided for use by service representatives who must install the
peeler unit. If the peeler is not installed, please contact your supplier.
(1) Check to make sure that the printer's power switch is turned off then disconnect the
power cord.
(2) Open the top cover and lift the thermal printhead and sensor arm.
(3) Remove the operation panel on
the front of the printer (2 screws).
When doing this, remove the
flexible cable that is connected
to the operation panel.
(4) Remove the front right cover on
the front of the printer. (2 screws)
Head open lever
Sensor arm open lever
Thermal printhead
Flexible cable
Sensor arm
Top cover
Operation
panel
Front right
cover
Note Installation requires a cross-point ('Phillips') screwdriver with magnetic tip and a
shaft at least 200 mm (8 inches) long.
Caution
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1

Installation Guide 7010 Peeler UnitThis guide is provided for use by service representatives who must install the peeler unit. If the peeler is not in

Pagina 2 - (2 screws)

(6) Remove the plastic cover from the front center cover that you have removed. (2 screws)Note The plastic cover that you have removed is needed if

Pagina 3

Release knobPeeler unitAlignment holes and pins(8) Attach the connector of the peeler unit to the daughter board as shown in the figure.Note The conn

Pagina 4

© Copyright DASCOM Europe GmbH v1.0(12) Attach the front right cover removed at step 4 in its original position. (2 screws)(13) Attach the operation

Comentarios a estos manuales

Sin comentarios