Dascom TallyCom III Set-up Guide for IBM System i/iSeries Manual de usuario descargar pdf (Pagina 8)

DASCOM AS/400 Set-up Guide Version 2.0 Page 8 of 10

4 SCS/DCA printing using TCP/IP

Once these parameters have been configured, and the basic TCP/IP installation of the

print server (equipped with an FSL top) has been completed, direct SCS/DCA will be

possible. This will off-load the AS/400 as Host Print Transform is not used.

Requirements:

2. AS/400 version 3.1 with TCP/IP installed and configured

3. TGNet print server with 5250 emulation

4.1 Create a remote output queue

The CRTOUTQ command is used to create a Remote output queue. This will enable the

AS/400 to automatically output SCS/DCA data directly to a TGNet print server.

The value *IP must be used for CNNTYPE

The value *OS400 must be used for DESTTYPE

The value *NO must be used for TRANSFORM

The value used for INTNETADR must be the same as the IP address of your TGNet.

4.2 AS/400 Printing

This method of printing supports various printer emulations. For Laser printers, all non-

IPDS emulations are supported. Matrix printers support the traditional IBM matrix

emulations.

When printing from OFFICE/400 care must be taken when submitting data to be printed.

The printer defined in the Print Option menu panel of OFFICE/400 must have a similar

emulation to the printer defined in the OUTQ parameter.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Dascom TallyCom III Set-up Guide for IBM System i/iSeries Manual de usuario Pagina 8