Dascom TallyCom III Installation & Operators Guide Manual de usuario descargar pdf (Pagina 20)

FSL Function Lookup Reference

FUNCTION 1: BUFFER SIZE

This function is used for changing default buffer size.

SYNTAX: %Y1,<n1>%

OPTION DESCRIPTION

1 960 characters

2 1920 characters

3 2560 characters

*4 3440 characters

5 3564 characters

NOTES:

1. This function should not be set during normal operation.

2. Once it has been programmed, the new value should be stored using the "escape X1"

command (see Storing and Restoring Settings) and the printer switched off for 10 seconds and then

on again.

EXAMPLE: %Y1,5%

will set the buffer size to 3564 characters

FUNCTION 2: LPI

This function is used for selecting default LPI.

SYNTAX: %Y2,<n1>%

OPTION DESCRIPTION

0 No LPI sent to printer

6 6 LPI

8 8 LPI

RELATED Y4, Line Spacing

Y5, Form Length

NOTES:

1. At power up the LPI value is loaded from the front panel setup of the printer. Function X1 has

no effect.

2. The system can request different values of LPI. If the system requires default LPI, the value

stored here will be used.

3. If Function 4 is set to 2 (double line spacing), then:

6 = 3 LPI

8 = 4 LPI

4. This function has immediate effect on the printer.

5. LPI from the host may overwrite default.

EXAMPLE: %Y2,8%

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

ok 11 Feb 2024 | 07:50:22

yes

Dascom TallyCom III Installation & Operators Guide Manual de usuario Pagina 20