Dascom 7206 Peeler Installation and User Guide Manual de usuario descargar pdf (Pagina 12)

– 12 –

3 How to operate

3-1 Operation

3-1-5 Peeler commands

The following are the peeler commands. For details of each command, see the

separate Command Reference.

Peeling position designated command STX f, STX Kf

This command designates the feeding amount from the reference point to the

peeling position.

Software switch setting command STX V

This command temporarily changes the contents of the option function setting in a

nonvolatile memory in the printer. With this command, the peeler function is turned

ON or OFF temporarily.

Note: If the label is at peeling position when the peeler function is selected, the

medial will not feed even if the Feed key is pressed. In this case, remove

the label first.

1 2 ... 7 8 9 10 11 12 13 14

Sin comentarios

Dascom 7206 Peeler Installation and User Guide Manual de usuario Pagina 12